Figure 4-1. Torque converter, exploded view.

TM 10-3930-242-34

Figure 4-1. Torque converter, exploded view.

diameter of one and five-sixteenths inches, and a

strips (25). Remove the six screws (24). Do not

maximum outside diameter of one and three-

r e m o v e the bearing retainers.

quarter inches. The studs must be 5/16 inch diame-

(i) Install a steel sleeve over the turbine

ter and have a minimum thread length of i n c h

s h a f t , and against the front of the converter

at one end. Overall length of stud must be of suffi-

ground sleeve. Install a puller on the steel

cient length to allow a nut travel of 1 inches

when nuts are tightened. The threads must be 5/16

sleeve, then using two studs, nuts and flat

in.-24.

w a s h e r s , pull the converter pump assembly (26)

f r o m the ground sleeve by tightening the nuts

(j) Disassemble the converter pump as-

evenly.

s e m b l y (26) by removing the bearing retainers

a n d tapping the accessory drive gear (28) and

NOTE

bearing (27) out of the converter pump. Remove

The steel sleeve must have a minimum length of

t h e bearing from the accessory drive gears.

o n e and three-quarter inches, a minimum inside