Figure 4-5. Muffler and exhaust pipe, removal and installation.
Section VIII. MAINTENANCE OF FUEL SYSTEM
(2) Refer to figure 4-6 and install the fuel
Drycleaning solvent, P-D-680 USed to
clean parts is potentially dangerous to
personnel and property. Do not use near
open flame or excessive heat. Flash point
of solvent is 138° F.
This section contains information for organizational
maintenance of the fuel system. This includes the
fuel pump, air cleaner and hose, and fuel filter.
4-19. Fuel Pump
a. Removal Refer to figure 4-6 and remove the
b. Cleaning and Inspection.
(1) Clean the fuel pump with drycleaning
solvent (item 1, App F), and dry thoroughly.
(2) Inspect the fuel pump for cracks, breaks, or
other damage. Replace if defective.
Figure 4-6. Fuel pump, removal and installation.
(1) Affix a new gasket to the body of the pump
and locate the pump drive coupling over the square
end of the fuel pump drive shaft.