ATTACHMENT CYLINDER REPAIR - continued

TM 10-3930-673-34

16-23. ATTACHMENT CYLINDER REPAIR (CONT)

WARNING

Drycleaning Solvent (P-D-680) is

TOXIC and flammable. Wear

protective goggles and gloves; use

only in a well-ventilated area;

avoid contact with skin, eyes, and

clothes; and do not breathe

vapors. Keep away from heat or

flame. Never smoke when using

solvent; the flashpoint for type I

drycleaning solvent is 100F

(38C), type II is 138F (59C),

and type III is 200F (93.3C).

Failure to do so may result in

TR01311

injury or death to personnel.

If personnel become dizzy while

using cleaning solvent,

immediately get fresh air and

medical help. If solvent contacts

skin or clothes, flush with cold

water. If solvent contacts eyes,

immediately flush eyes with

water and get immediate medical

attention.

(f)

Use a cleaning solvent and lint-free rag to clean threads on rod (2) and nut (9).

(g)

Install piston (6) on rod (2).

(h)

Apply sealing compound on threads of rod (2) and nut (9). Install nut on rod.

(i)

Place rod (2) and piston (6) as an assembly on supports to prevent damage during assembly.

(j)

Install two wear rings (7) and one seal (8) on piston (6). Position wear rings so that gaps are

180 degrees apart.

CAUTION

Use care when installing rod and piston assembly. Keep rod in line with cylinder tube to

prevent binding.

(k)

Lubricate cylinder tube (4) inside diameter, piston (6) outside diameter and gland (3) outside

diameter with clean hydraulic oil.

(l)

Position rod (2) and piston (6) as an assembly in cylinder tube (4).

16-134