HYDRAULIC JOYSTICK CONTROL VALVE REPAIR - continued

TM 10-3930-673-34

16-22. HYDRAULIC JOYSTICK CONTROL VALVE REPAIR (CONT)

(4)

Apply grease to contact surfaces of

ball joint (5) and plate (7).

(5)

Install ball joint (5) in plate (7) from

bottom side. Use care not to dislodge

ball joint.

(6)

Install clamp (3) on plate (7).

WARNING

Adhesives, solvents, and sealing

compounds can burn easily, can give

off harmful vapors, and are harmful

to skin and clothing. To avoid injury

or death, keep away from open fire

and use in a well-ventilated area. If

adhesive, solvent, or sealing

compound gets on skin or clothing,

wash immediately with soap and

water.

(7)

Apply sealing compound on threads

of screws (6). Install screws in

housing (8). Tighten screws to 15 lb-

TR01768

ft (20.34 Nm).

(8)

Install plate (4) onto ball joint (5) until bottom of pivot plate just contacts tops of

plungers (13). Lock plate in position with nut (2). Tighten nut to 29 - 41 lb-ft (39.32 -

55.59 Nm).

(9)

Install boot (1) on clamp (3).

NOTE

Follow-on Maintenance: Install hydraulic joystick control valve (TM 10-3930-673-20).

END OF TASK

16-130