CAB ASSEMBLY WITH ROPS/FOPS REPLACEMENT/REPAIR - continued

TM 10-3930-673-34

14-3. CAB ASSEMBLY WITH ROPS/FOPS REPLACEMENT/REPAIR (CONT)

(43)

Install steering wheel and column (TM 10-3930-673-20).

(44)

Install turn signal switch (TM 10-3930-673-20).

f. Installation.

WARNING

Cab weighs in excess of 800 lb

(363.2 kg). Attach suitable lifting

TR00004

device prior to installation to

prevent possible injury to personnel.

(1)

Use a hoist and sling to position cab

on vehicle.

WARNING

Adhesives, solvents, and sealing

compounds can burn easily, can give

off harmful vapors, and are harmful

to skin and clothing. To avoid injury

or death, keep away from open fire

and use in a well-ventilated area. If

adhesive, solvent, or sealing

compound gets on skin or clothing,

wash immediately with soap and

water.

NOTE

Use washers to shim cab so cab side

plate to boom hoist cylinder anchor

clearance with vehicle level and

TR01789

boom centered, is 2.75 in.

(69.85 mm) minimum. Shim both

upper cab mounts equally. Use as

few washers as possible. Do not

overshim.

(2)

Align cab and frame mounting holes. Apply sealing compound to threads of two

screws (33 and 34). Install two screws (33), two screws (34), eight washers (30), three

washers (31), four rubber washers (32), and four nuts (29) in cab and vehicle frame (7).

Tighten nuts to 640 lb-ft (867.72 Nm).

(3)

Remove hoist and sling from cab.

14-10