 |
|||
|
|
|||
|
Page Title:
DRIVE WHEEL SPINDLE REPLACEMENT/ADJUSTMENT - continued |
|
||
| ||||||||||
|
|
 TM 10-3930-673-34
(5)
Install upper drive wheel spindle
3
cap (1) on drive wheel spindle (8).
(a)
Install shims (9, 10, and 11) on
1
upper drive wheel spindle cap (1).
9
(b)
Install upper drive wheel spindle
cap (1) and shims (9, 10, and 11) as
an assembly on drive spindle (8).
10
11
WARNING
Adhesives, solvents, and sealing
8
compounds can burn easily, can give
off harmful vapors, and are harmful
to skin and clothing. To avoid injury
or death, keep away from open fire
and use in a well-ventilated area. If
adhesive, solvent, or sealing
compound gets on skin or clothing,
wash immediately with soap and
water.
TR00487
(c)
Apply sealing compound to threads
of four screws (3). Install screws in upper drive wheel spindle cap (1). Tighten screws to
85 - 115 lb-ft (115.24 - 155.92 Nm).
(6)
Install tie rod (Para 12-6).
(7)
Adjust tie rod (TM 10-3930-673-20).
e. Adjustment.
(1)
Measure vertical end play.
(a)
If wheels are on ground: Use a feeler gauge to measure gap between upper drive wheel
spindle cap shoulder and top machined surface of end of the axle housing.
(b)
If wheels are removed (axle supported by blocks): Use a hydraulic jack or pry bar to push
drive wheel spindle up until bottom of drive wheel spindle is tight against bottom of axle.
Measure gap as in Step (a).
(c)
Vertical end play may also be measured by checking maximum vertical movement of knuckle
with a dial indicator.
(d)
Record measurement.
(2)
Vertical end play limits:
(a)
If end play is 0.013 in. (0.33 mm) or less, no adjustment is necessary.
(b)
If vertical end play exceeds 0.013 in. (0.33 mm), go to Step (3).
12-7
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals