DISC BRAKE ASSEMBLY REPLACEMENT/REPAIR - continued

TM 10-3930-673-34

10-3. DISC BRAKE ASSEMBLY REPLACEMENT/REPAIR (CONT)

f. Installation.

NOTE

Remove caps and plugs as hoses are

installed. Wipe all sealing surfaces

on disc brake clean and dry.

(1)

Position disc brake caliper (6) on

drive wheel spindle (5) and disc.

(a)

Check proper location of disc brake

caliper (6) in relation with disc.

(b)

Verify that disc is centered between

disc brake housing (2).

TR00467

WARNING

Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors,

and are harmful to skin and clothing. To avoid injury or death, keep away from open fire

and use in a well-ventilated area. If adhesive, solvent, or sealing compound gets on skin

or clothing, wash immediately with soap and water.

(2)

Apply sealing compound on threads of four screws (3). Install four washers (4) and

screws (3) on brake housing (2) and drive wheel spindle (5). Tighten screws to 280 lb-ft

(379.63 Nm).

(3)

Connect brake (1) to brake housing (2).

NOTE

Follow-on Maintenance:

Install service brake shoes (TM 10-3930-673-20).

Check to see that linings are free to move.

Bleed air from brakes (TM 10-3930-673-20).

END OF TASK

10-8