TRANSMISSION ASSEMBLY REPLACEMENT/REPAIR - continued

TM 10-3930-673-34

(f)

Remove snap ring (105) and clutch

plate retainer (106) from shaft

assembly (99).

NOTE

The third stage clutch pack contains

four clutch plates and four separator

plates.

(g)

Remove four clutch plates (107) and

four separator plates (108).

WARNING

Springs are under tension. Always

wear safety glasses when working

TR00218

on compressed springs. Carefully

handle spring in compressed form.

Failure to follow this precaution

could cause personal injury.

(h)

Place shaft assembly (99) in a press. Install a clutch spring compressor tool.

(i)

Press down on spring compressor tool and retainer (109) just enough to relieve pressure on

retainer ring (110). Remove retainer ring. Slowly remove clutch spring compressor tool.

(j)

Remove retainer (109), four springs (111) and thrust washer (112).

WARNING

Do not exceed 15 psi (103.43 kPa) nozzle pressure when using compressed air. Do not

direct compressed air against skin. Failure to follow this precaution could cause personal

injury.

(k)

Insert air nozzle at pressure ports (A) located between three seal ring grooves on shaft

assembly (99). Use compressed air to remove piston (113).

(l)

Remove preformed packing (114)

and outer piston seal (115). Discard

preformed packing and seal.

TR00219

7-23