TRANSMISSION ASSEMBLY REPLACEMENT/REPAIR - continued

TM 10-3930-673-34

WARNING

Use care when removing snap and

retaining rings. Snap and retaining

rings are under spring tension and

can act as projectiles when released

and could cause severe eye injury.

(l)

Remove snap ring (88) from shaft

assembly (77).

TR00213

(m) Use a gear puller to remove weld

gear (89) and two bearings (90) as an

assembly from shaft assembly (77).

WARNING

Springs are under tension. Always

wear safety glasses when working

on compressed springs. Carefully

handle spring in compressed form.

Failure to follow this precaution

could cause personal injury.

(n)

Place shaft assembly (77) in a press.

Install a clutch spring compressor

tool.

(o)

Press down on spring compressor

tool and retainer (91) just enough to

relieve pressure on retainer

ring (92). Remove retainer ring.

TR00214

Slowly remove clutch spring

compressor tool.

(p)

Remove retainer (91), four springs (93), and thrust washer (94).

WARNING

Do not exceed 15 psi (103.43 kPa) nozzle pressure when using compressed air. Do not

direct compressed air against skin. Failure to follow this precaution could cause personal

injury.

(q)

Insert air nozzle at pressure ports (A) located between three seal ring grooves on shaft

assembly (77). Use compressed air to remove piston (95).

7-21