Installation - continued - TM-10-3930-673-340183

TM 10-3930-673-34

TR01420

(j)

Install lower bearing half (6), bearing cap (3), and two screws (4) on bearing bore with the

same number as that stamped on cap, with number facing towards the oil cooler side of

engine.

(k)

After installing each bearing and bearing cap, tighten screws (4) to 37 lb-ft (50.17 Nm). Do

not tighten screws to final torque value at this time.

(l)

Repeat Steps (a) through (k) for the other main bearing positions (2 through 5) and thrust

bearing (2) at position no. 6.

(m) Tighten screws (4) evenly in the sequence shown to 44 lb-ft (59.66 Nm).

(n)

Tighten screws (4) evenly again in the sequence shown to 88 lb-ft (119.31 Nm).

(o)

Tighten screws (4) evenly in the sequence shown to 129 lb-ft (174.90 Nm) final torque.

3-81