PREPARATION FOR SHIPMENT-CONT.

TM 10-3930-673-20-2

NOTE

Perform following steps to load and secure vehicle on FLAT-BED TRAILER.

i. Fully retract the boom.

j. Drive vehicle onto trailer such that rear of forklift faces forward. With 6K carriage stowed and "locked" onto 10K

carriage, lower the boom and level the forks so 6K forks are approximately 4 in (102 mm) off deck of trailer.

k. Apply parking brake. Place transmission in Neutral.

l. Secure vehicle to trailer as shown on illustration on the following page.

m. Shut down engine.

n. Tape boom angle indicator arm to angle indicator plate. Do not apply tape to CARC paint.

o. Using duct tape, seal exhaust outlet, engine air intake and crankcase breather tube.

p. Tie wrap 6K fork sideshift hoses to 6K backrest. Ensure hoses are not chafing against any sharp edges.

q. Truck driver is responsible for securing ATLAS vehicle.

r. Secure Exhaust Fuel shipping tag to engine run control in cab.

s. Clean cab interior of dirt and debris.

t. Rotate left-side mirror fully to right.

u. Rotate right-side mirror bracket toward rear of vehicle with glass facing boom.

v. Rotate cab spotlights down and in towards cab.

w. Apply a light coat of oil to rods of frame tilt cylinder, carriage tilt cylinder, attachment cylinder, fork sideshift cylinders,

boom hoist cylinders and four steering cylinders.

x. Apply a light coat of oil to exposed ends of transmission shifter cables.

y. Place the following items in toolbox:

(a)

Emergency boom lift and retract kit.

(b)

Counterweight removal pendant kit.

(c)

Counterweight removal shackles.

(d)

Place padlock (without chain) and two keys for padlock into cardboard padlock box and tape box closed.

Place padlock box into toolbox.

z. Attach chain of other padlock to rear hinge of toolbox. Close toolbox and secure toolbox with the padlock. Attach two

keys to ring of loose leaf binder in cab.

aa. Check state and local laws governing weight, width and length of load.

Change 1

21-5