Installation - TM-10-3930-673-20-20434

TM 10-3930-673-20-2

14-7. STEERING CYLINDERS REPLACEMENT (CONT)

(1)

Deleted.

TR00002

(2)

On rod end of steering cylinder (1),

remove cotter pin (2) and nut (3).

Discard cotter pin.

CAUTION

Do not strike nut on side to remove

steering cylinder. Damage to ball joint

end cap may occur.

(3)

Separate steering cylinder (1) from

ball joint end cap (4).

(4)

Remove parts (5 through 7) from

other end of steering cylinder (1)

and cylinder from axle (8).

TR00654

(a)

Remove cotter pin (5) and nut

(6) from ball joint end cap (7).

Discard cotter pin.

(b)

Separate steering cylinder (1) from ball joint end cap (7) and vehicle.

b. Installation.

(1)

Install parts (5 through 7) in end of steering cylinder (1) and axle (8).

(a)

Position steering cylinder ball joint end cap (7) in tapered hole on axle (8).

(b)

Install nut (6) on steering cylinder ball joint end cap (7). Tighten nut to 250 lb-ft (338.9 Nm).

(c)

Tighten nut (6) until holes align and install new cotter pin (5) on steering cylinder ball joint end cap (7). Do

not loosen nut to install cotter pin.

(2)

Position steering cylinder ball joint end cap (4) in tapered hole on axle (8) at rod end.

(3)

Install nut (3) and tighten to 250 lb-ft (338.9 Nm).

Tighten nut (3) until holes align and install new cotter pin (2). Do not loosen nut to install new cotter pin.

14-18

Change 1