Repair - TM-10-3930-673-20-20408

TM 10-3930-673-20-2

13-2. WHEEL ASSEMBLY REPLACEMENT/REPAIR (CONT)

c. Installation.

WARNING

Wheel assembly weighs approximately 465 lbs. Two personnel are required to position wheel

assembly on vehicle wheel hub. Failure to follow this precaution could result in serious injury or death

to personnel.

(1)

Place floor jack under axle housing (3) on same side as wheel assembly (2) to be installed. Raise vehicle as

required until axle housing is off of jackstand and wheel hub (6) is high enough for installation of wheel

assembly (2).

(2)

With aid of assistant, position wheel assembly (2) on wheel hub (6). Install but do not tighten twelve wheel

nuts (5) until nuts are seated.

(3)

Remove jackstand from under axle housing (3).

(4)

Lower vehicle with floor jack until tire (1) is just resting on ground.

13-4