Repair - TM-10-3930-673-20-20322

TM 10-3930-673-20-2

8-51. STE/ICE WIRING HARNESS TEST/REPAIR/REPLACEMENT (CONT)

(4)

Disconnect connector (5) from resistor module (6). Remove four nuts (7), lockwashers (8), and screws (9).

Discard lockwashers.

(5)

Remove cap (10) from diagnostic connector (11).

(6)

Remove four nuts (12), lockwashers (13) and screws (14) from diagnostic connector (11). Discard

lockwashers.

(7)

Disconnect three connectors (15 through 17) from fuel pressure (18), fuel filter (19) and fuel solenoid (20).

NOTE

Remove tie wraps as necessary.

(8)

Remove wiring harness (3) from vehicle.

c. Repair.

NOTE

If 30 percent or more of wires in wiring harness have been repaired or replaced, replace complete

harness.

(1)

Replace any broken terminal rings or connectors.

(2)

Replace any faulty wires.

(a)

Note both connection points of faulty wire. Disconnect faulty wire at both ends.

(b)

Cut exposed wire and terminals from both ends of faulty wire.

(c)

Cut replacement wire to required length and install proper terminals.

(d)

Route replacement wire along wiring harness, securing wire with tie straps or electrical tape.

(e)

Connect replacement wire to original connection points.

(f)

Test circuit function.

d. Installation.

NOTE

Install tie wraps as necessary.

(1)

Route wiring harness (3) on vehicle.

(2)

Connect three connectors (15 through 17) on fuel pressure (18), fuel filter (19), and fuel solenoid (20).

(3)

Install diagnostic connector (11) with four screws (14), lockwashers (13) and nuts (12).

8-168