 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-673-20-2
c. Removal.
NOTE
If an individual wire in a wire harness is broken, it is not necessary to replace entire wire harness
(refer to b. Repair above).
Remove cable ties as necessary.
(1)
Tag and mark connection points of all terminal rings and single connectors on wiring harness. Disconnect
terminal rings and single connectors.
(2)
Tag, mark and disconnect four plug-type connectors.
(3)
Remove all clamps securing wiring harness to cab structure.
d. Installation.
(1)
Route new wiring harness in same path as old wiring harness.
(2)
Install cable clamps in original locations.
(3)
Connect four plug-type connectors.
(4)
Connect individual terminal rings and single connectors according to tags marked during removal. Refer to
schematic diagram for wire numbers and connection points.
(5)
Connect negative battery cable (refer to Para 8-44).
(6)
Test all circuits to confirm proper installation of wiring harness.
END OF TASK
8-153
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals