ENGINE PRODUCES EXCESSIVE BLACK EXHAUST SMOKE - continued

TM 10-3930-673-20-1

WARNING

Drycleaning solvent P-D-680 (Type II) is a flammable solvent that is potentially dangerous to personnel. Keep away from heat,

sparks, or open flame. Flash point of solvent is 138 degrees F (59 degrees C). Use only in a well-ventilated area. Inhaling vapors

over a period of time can cause headache and drowsiness. Use gloves to prevent irritation or inflammation of the skin. Solvent

absorbed through the skin can result in internal disorders. If contact occurs, wash the affected area with water for 15 minutes. For

eyes, flush with water and then seek immediate medical attention.

Improper cleaning methods and use of unauthorized cleaning solvents may injure personnel and damage equipment. Refer to

TM9-247 for correct information.

Eye shields must be worn when cleaning with a wire brush. Flying rust and metal particles may cause injury to personnel.

Particles blown by compressed air are hazardous. Make certain the air stream is directed away from user and other personnel in

the area. To prevent injury, user must wear protective goggles or face shield when using compressed air.

CAUTION

Washing oil seals, electrical cables and flexible hoses with dry cleaning solvents or mineral spirits will cause serious damage or

destroy materials.

RANGE SELECT

GEAR RANGE OPERATION AND LOAD

ONTROL

VISUAL INSPECTION

Check that gear range in use is correct for

operation and load

(TM 10-3930-673-10).

(a) If gear range is correct, go to

Step 2 of this fault.

(b) If gear range is too high, shift to

lower gear (TM 10-3930-673-10).

TR01219

2-657