STEERING SELECT SWITCH DOES NOT OPERATE - continued

TM 10-3930-673-20-1

Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on

equipment and cause injury or short across electrical circuit and cause severe burns or electrical shock.

Battery acid is harmful to skin and eyes. Always wear eye protection when working with batteries.

ACCESS

ANEL

VOLTAGE TEST

(1) Remove battery cover (Para 8-42).

(2) Disconnect negative battery cable from

negative side of battery (Para 8-42).

SCREW

(3) Remove four screws and access panel.

(4) Set multimeter to volts dc.

(5) Connect multimeter positive lead (+) to

circuit breaker CB9 where wire 3

connects.

(6) Connect multimeter negative lead () to

known good ground.

(7) Connect negative battery cable to

negative side of battery (Para 8-42).

(8) Turn engine start switch to ON position,

BUT DO NOT START ENGINE

(TM 10-3930-673-10).

(a) If voltage is present, go to Step 2

WIRE 3

of this fault.

(b) If voltage is not present, repair

wire 3 (Para 8-48).

(9) Turn engine start switch to OFF

position (TM 10-3930-673-10).

(10) Disconnect negative battery cable from

negative side of battery (Para 8-42).

CIRCUIT

REAKER CB9

TR01586

2-591