FORK AUTO-LEVELER DOES NOT OPERATE - continued

TM 10-3930-673-20-1

Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on

equipment and cause injury or short across electrical circuit and cause severe burns or electrical shock.

Battery acid is harmful to skin and eyes. Always wear eye protection when working with batteries.

CONTINUITY TEST

ENGINE

START

(1) Remove indicator light from socket.

SWITCH

(2) Set multimeter to ohms.

(3) Connect multimeter positive lead (+) to

center conductor of indicator light.

(4) Connect multimeter negative lead () to

outside conductor of indicator light.

(a) If continuity is present, go to Step 3

of this fault.

(b) If continuity is not present, replace

lamp (Para 8-9).

INDICATOR

LIGHT

CENTER

OUTSIDE

CONDUCTOR

VOLTAGE TEST

(1) Remove four screws from left-hand

LIGHT

instrument panel.

SOCKET

(2) Raise panel out to reach auto-level

light socket.

(3) Disconnect negative battery cable from

WIRE 50

negative side of battery (Para 8-42).

(4) Set multimeter to dc.

(5) Connect multimeter positive lead (+) to

wire 50 where wire 50 connects to

socket.

(6) Connect multimeter negative lead () to

known good ground.

(7) Connect negative battery cable (1) to

negative side of battery (2) (Para 8-42).

WIRE 59

(8) Turn engine start switch to ON position,

BUT DO NOT START ENGINE

(TM 10-3930-673-10).

(9) Turn auto-level switch to ON

(TM 10-3930-673-10).

(a) If voltage is present, go to Step 4

TR01748

of this fault.

(b) If voltage is not present, repair

wire 50 (Para 8-48).

(10) Turn auto-level switch OFF

(TM 10-3930-673-10).

(11) Turn engine start switch to OFF

position (TM 10-3930-673-10).

2-471