|
|
TM 10-3930-673-20-1
VOLTAGE TEST
(1) Disconnect negative battery cable from
negative side of battery (Para 8-42).
(2) Set multimeter to volts dc.
(3) Disconnect wire 25 or 26 from turn
signal flasher.
(4) Connect multimeter positive lead (+) to
male blade connector of flasher where
wire 25 or wire 26 connect.
(5) Connect multimeter negative lead () to
known good ground.
(6) Connect negative battery cable to
negative side of battery (Para 8-42).
(7) Turn engine start switch to ON position,
BUT DO NOT START ENGINE
(TM 10-3930-673-10).
(8) Turn on turn signal for appropriate turn
signal wire (right wire 26, left wire 25
[TM 10-3930-673-10]).
(a) If 24 vdc is present, go to Step 13
of this fault.
(b) If 24 vdc is not present, replace
turn signal flasher (Para 8-24).
(9) Turn engine start switch to OFF
position (TM 10-3930-673-10).
(10) Disconnect negative battery cable from
negative side of battery (Para 8-42).
(11) Connect wire 25 or 26 to turn signal
flasher.
F
TURN SIGNAL
VOLTAGE TEST
LASHER
(1) Set multimeter to volts dc.
(2) Disconnect wire 25 or 26 from turn
signal flasher.
WIRE 25
(3) Connect multimeter positive lead (+) to
female blade receptacle of wire 25 or
wire 26.
(4) Connect multimeter negative lead () to
TR01727
known good ground.
WIRE 26
(5) Connect negative battery cable to
negative side of battery (Para 8-42).
(6) Turn engine start switch to ON position,
BUT DO NOT START ENGINE
(TM 10-3930-673-10).
(7) Turn on turn signal for appropriate turn
signal wire (right wire 26, left wire 25
[TM 10-3930-673-10]).
(a) If 24 vdc is present, go to Step 14
of this fault.
(b) If 24 vdc is not present, repair wire
25 or wire 26 (Para 8-48).
(8) Turn engine start switch to OFF
position (TM 10-3930-673-10).
(9) Disconnect negative battery cable from
negative side of battery (Para 8-42).
(10) Connect wire 25 or 26 to turn signal
flasher.
2-209
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |