EXPLANATION OF COLUMNS (SECTION IV). - TM-10-3930-671-24P0010

TM1 -3930-471-24P

3. EXPLANATION OF COLUMNS (SECTION II) (CONT).

(4) The statement "END OF FIGURE" appears just below the last item description m Column 5 for a given

f. QTY (Column(6)). The QTY (quantity per figure column) indicates the quantity of the item used the breakout

shown on the illustration figure, which is prepared for a functional group, sub functional group, or an assembly. A "V'

appearing in this column in lieu of a quantity indicates that the quantity is variable and the quantity may vary from

application to application.

4. EXPLANATION OF COLUMNS (SECTION IV).

a. National Stock Number (NSN) Index.

(1) Stock Number column. This column lists the NSN by National Item Identification Number (NIIN) sequence.

The NIIN consists of the last nine digits of the NSN, i e.

NSN

NSN i. (5305-01-574-1467)

NIIN

When using this column to locate an item, ignore the first 4 digits of the NSN However, the complete NSN should be used

when ordering Items by stock number

(2) FIG column. This column lists the number of the figure where the item is identified/located The figures are in

numerical order in Section H.

(3) ITEM column. The item number identifies the item associated with the figure listed in the adjacent FIG.

column This item is also identified by the NSN listed on the same line.

b. Number Index. Part numbers in this index are listed by part number in ascending alphanumeric sequence (i.e.,

vertical arrangement of letter and number combinations which places the first letter or digit of each group m order A

thorough Z, followed by the number 0 through 9 and each following letter or digit in like order).

(1) CAGE column. The Commercial and Government Entity Code (CAGEC) is a 5-digit numeric code used to

identify the manufacturer, distributor, or Government agency, etc., that supplies the item.

(2) PART NUMBER column. Indicates the primary number used by the manufacturer (individual, firm,

corporation, or Government activity), which controls the design and characteristics of the item by means of

its engineering drawings, specifications and inspection requirements to identify and item or range of items.

(3) STOCK NUMBER column. This column lists the NSN for the associated part number and manufacturer

identified in the PART NUMBER and CAGEC columns to the left.

(4) FIG column. This column lists the number of the figure where the item is identified/located in Sections II and

(5) ITEM column. This item number is that number assigned to the item as it appears in the figure referenced in

the adjacent figure number column.

c. Figure and Item Number Index.

(1) FIG column. This column lists the number of the figure where the item is identified/located in Sections II and