| |
TM 10-3930-671-24
Upright Installation
2.
Raise the front of truck. Put blocking under each
side of the frame.
3.
Remove drive wheels. For best access to
upright mounting trunnion fasteners.
4.
As required, install upright mounting brackets on
upright. See Note above. Tighten bolts to
torque spec: 273-302 lb ft (370-410 Nom).
5.
Attach lifting chains and hoist to upright.
6.
Lift and move upright into position to install on
truck.
7.
Install trunnion bearings on axle and trunnion
cap. Apply generous coating of Grade #1 Lithium
soap base multipurpose grease to trunnion
bearings.
Fill
bearings
(lube
fitting)
after
installation with same grease.
8.
Install RH and LH trunnion caps. See Note
above.
Install
bolts
(and
washers,
if
specified)Tighten bolts to torque spec: 55-59 lb
ft (75-80 N0m).
9.
Connect the tilt cylinders to upright. Be sure to
install rod end pin bearing with grease fitting in
upright. See Section 10.7.
10.
Connect the hydraulic lift line(s).
11.
Install drive wheels.
12.
Raise truck and remove blocking from under the
frame. Remove hoist.
13.
Install hydraulic attachments and equipment as
applicable, forks, etc.
F-505 (F-506 blank)
|
