TM 10-3930-671-24 Tilt Cylinder Installation 1. Repack   anchor   pin   and   rod   end   pin   bearings with Grade No. 2 Lithium soap base multipurpose. grease, Clark MS-107C or equivalent, before installation. 2. Install anchor pin bearing and spacer into frame socket. 3. Position tilt cylinder in its mounting location over frame socket and bearing. Install the anchor pin. 4. Install anchor pin retainer washer and capscrew. 5. Install rod end pin bearing in upright bracket. 6. Align   rod   end   yoke   with   upright   bracket   and install rod end pin through the yoke and bearing. Move upright as necessary for alignment. 7. Install the rod end pin retainer. Install and tighten pin retainer fastener. 8. Install the hydraulic tilt lines. 9. Remove chain hoist and lift chain from upright. F-480