TM 10-3930-671-24 Power Steering Cylinder and Tie Rod Arms Removal Figure 2. 1. Remove  cotter  pin  and  washer  from  steer  arm pin  at  each  steering  knuckle.    Remove  the  pin and  disassemble  tie  rod  arm  (steer  link)  from each steering knuckle. NOTE Pins  from  cylinder-rod  end  of  tie  rod arms  can  be  removed  after  removal of cylinder from axle, Step 5 below. 2. Loosen  and   remove   the   four   steering   cylinder mounting fastener bolts. Inspect the tie rod arm bearings for wear and damage. 3. Remove steering cylinder from steer axle body. 4. Check steering cylinder locator pin which should remain pressed in axle body. 5. Disassemble  the  tie  rod  arms  from  each  end  of steering cylinder rod. Steering Cylinder Disassembly Refer to Section 9.13, Steering Cylinder Overhaul (Type 2). Inspect the tie rod arm bearings for wear and damage.  If these   bearings   require   replacement,   remove   them   by use  of  an  arbor  press  or  by  carefully  driving  them  out using a metal tool such as a section of pipe or tubing of the  correct  size.    Install  new  bearings  by  pressing  into place. F-435