TM 10-3930-671-24 9.12. Steer Axle Overhaul (Type 2) Steer Axle Type 2............................................................................................F-431 Preparation for Disassembly ...........................................................................F-431 Steer Axle - (Type 2) Parts Nomenclature ......................................................F-432 Disassembly ....................................................................................................F-433 Parts Inspection...............................................................................................F-436 Assembly.........................................................................................................F-437 Steer Axle Type 2 Refer to Section 9.7, Steer Axle Removal/lnstallation, for removal of steer axle assembly from truck. This  steer  axle  has  a  one-piece  fabricated  main  body assembly    using    steel    box-type    construction.          The steering  cylinder  is  an  integral  separate  2-way  actuator mounted   within   the   main   body   and   joined   to   steering knuckles by links.  All bearings are replaceable and have lubrication fittings. Preparation for Disassembly NOTE Cleanliness is of extreme  importance in   the   repair   and   overhaul   of   this assembly. 1. Before  starting  disassembly,  thoroughly  clean the axle assembly of all accumulations of dirt, oil, corrosion    and    other    substances    to    prevent contamination  of  the  parts   during   disassembly and over-haul. 2. Work in a clean area. 3. Keep     all     parts     in     order     as     disassembly progresses.  Take care to properly identify each part and its order of removal.  If necessary, keep notes  and  put  markings  on  parts  using  a  non- destructive marker such as a felt-tipped pen. F-431