| |
TM 10-3930-671-24
Service Brake Adjustment (contd)
TA1 8 Transaxle
Figure 2. Service Brake Access Openings in Wheel Hub
Adjustment Thru Wheel Hub
NOTE
Openings in the wheel hub/brake drum have
been provided for easier access to check and
adjust the service brakes from the outer side.
The opening is enclosed with a dust cover held
in place by a single screw.
1.
Remove wheel and tire assembly from wheel
hub.
2.
Remove dust cover from access opening in
wheel hub/brake drum
3.
Use a feeler (thickness) gauge to check the
clearance between each shoe and drum. Use a
screwdriver or equivalent tool to rotate the
adjustor ratchet wheel in the brake.
4.
Use a tool with a hook to pull on and release the
ratchet pawl when it is necessary to back off
adjustment (increase clearance) of the brake.
NOTE
Do not overtighten brakes. It is very difficult to
release the ratchet wheel pawl and back off
adjustment of the brake.
5.
Carefully adjust clearance between brake shoes
and drum to .010-.012 in. (0.255-0.304 mm)
measured at slot opening. Move slot by rotating
brake drum to check clearance, at positions
shown by Fig.4, on each brake shoe.
6.
After adjusting brakes, install dust cover over
access opening in wheel hub.
7.
Install wheel and tire assembly on drive axle
wheel hub.
8.
Install wheel mounting lug nuts and tighten to
torque spec: 470-530 Ib-ft (637-718 N-m).
F-393
|