TM 10-3930-671-24 13. Install   converter   housing   on   adapter   plate   (fit over   dowels)   and   to   transmission   case.      Be careful not to damage converter housing oil seal when moving over the stator support. 14. Install   adapter   plate   to   converter   housing   and converter housing to transmission housing attaching  screws  and  lockwashers.    Tighten  to torque spec:  23-25 lb-ft.  (31-34 Nom). 15. Install oil pressure regulator valve sleeve assembly   through   the   spacer   plate   and   into converter  housing.    Tighten  regulator  sleeve  to torque spec:  45-50 lb-ft.  (61-68 Nom). 16. Install oil filter on regulator sleeve per instructions on filter. 17. Install  charging  pump  with  attaching  bolts  and washers and tighten to torque spec:  12-16 lb-ft. (16-22 N.m). 18. Install   control   valve   assembly   to   transmission case    with    attaching    bolts    and    washers    and tighten to torque spec:  12-16 lb-ft.  (16-22 Nom). 19. Install oil supply tube assembly. 20. Install torque converter assembly by sliding onto stator support.  Carefully align splines with stator and  impeller  hub  gear.    Again  use  care  not  to damage converter housing oil seal. F-376