TM 10-3930-671-24 H. Stator Support Assembly 1. Install the turbine shaft bushing and clutch outer pilot   bearing   into   stator   support.      Press   the bushing to the specified depth. 2. Install  stator  support  assembly  in  adapter  plate (Reverse of disassembly procedure): 1 - Assemble front retainer ring on stator support but do not   install   in   front   ring   groove;   temporarily   position   it beyond the groove to the forward end of the rear spline. Position  the  impeller  hub  gear  thrust  washer  on  stator support and against retainer ring. 2  -  From  the  front,  assemble  stator  support  into  spacer plate.      Push   stator   support   through   plate   until   rear retainer ring groove is exposed.  Install rear retainer ring. 3  -  Push  stator  support  toward  the  front  until  rear  ring shoulders against spacer plate. 4  -  Push  thrust  washer  back  against  plate  and  install front retainer ring in groove. I. Transmission Assembly 1. Install the clutch shaft oil distributor in transmission     case     with     the     recess     in     the distributor lined  up  with  retaining  set  screw  hole in valve housing pad. 2. Install the oil distributor retaining set screw. 3. Install turbine (clutch) shaft inner (rear) bearing. 4. Install reverse idler shaft inner (rear) bearing. 5. Install clutch and idler gear shafts.  The forward and   reverse   clutch   assembly   and   the   reverse idler gear must be assembled in the transmission case together.  Carefully move and align  the  clutch  shaft  oil  seal  rings  through  the rear bearing and into the oil distributor.  Be sure the reverse idler is fully in F-374