TM 10-3930-671-24 Transaxle Reassembly Assembly Notes: 1.   Use Permatex and Loctite only where specified. 2.   All  lead-in  chamfers  for  oil  seals,  piston  ring  grooves  and  O-rings  must  be smooth and free from burrs. Inspect at assembly. 3.   Lubricate  all  piston  ring  grooves,  clutch  plates  and  O-rings  with  oil  before assembly. 4.   Apply  a  thin  coating  of  grease  between  seal  lips  of  lip-type  oil  seals  prior  to assembly. 5.   Apply a very light coating of Permatex No. 2 to O.D. of all seals and hole plugs before assembly. 6.   Apply a light coating of Loctite No. 592 to all uncoated pipe plugs. 7.   After assembly of parts using Permatex or Loctite, there must not be any free or excess material that could enter the oil system. 8.   Brush light coating of Texaco 8570 or equivalent oil, on tapered bearings and bushing bores. F-365