TM 10-3930-671-24 NOTE Be  sure  new  or  rebuilt  pump  is  well oiled prior to installation. 11. Install the main  hydraulic  pump  on  transmission using  a  new  gasket.    Install  and  tighten  pump mounting bolts to torque spec: 37-41 Ib-ft (50-56 N•m) Refer  to  Section  10.3,  Main  Hydraulic  Pump  Removal/ Installation. 12.    Install the hydraulic lines to main pump.  Be sure the O-ring seals are properly positioned. Refer   to   Section   10.0,   Main   Hydraulic   and   Steering Lines. 13.    Reconnect the brake lines.  See Section 8.4. 14.    Tighten  brake  line  tube  fittings  to  torque  spec; 135-145 lb-in (15-16 N-m). NOTE After  installation  of   transaxle   in   the truck,  the  entire  brake  system  must be   bled   to   remove   all   air   from   the system   according   to   recommended brake  bleeding  procedure.    Refer  to Section 8.5, Brake Bleeding Procedures (TA18 transaxle). 15.    Install new transmission oil filter. 16.    Install   the   transmission   cooling   lines   to   the transaxle.         Be   sure   they   are   in   the   correct position (refer to the markings placed on them at removal). Refer to Section 4.8 Cooling System. 17.    Install  the  power  steering  lines  to  the  steering gear  (valve).    Be  sure  they  are  installed  to  the correct  ports  (refer  to  the  markings  placed  on them at removal). Refer to Section 9.  , Steering System and Section 10.0, Main Hydraulic and Steering Lines. 18.    Connect the steer valve sump return line at  the sump tank inlet. 19.    Install the accelerator linkage, as required. 20.    Reconnect the directional control  (shift)  linkage. Reconnect wiring leads to control cover solenoid terminals.    Check  the  markings  on  them  to  be sure each is installed on the correct solenoid. Refer to Section 7.12, Directional Control Linkage. F-339