| |
TM 10-3930-671-24
CAUTION
Be sure truck is correctly raised and
safely
blocked
using
metal
or
hardwood blocks under the frame.
Be sure the blocking will permit
removal
and
installation
of
the
transaxle
without
disturbing
the
blocking.
9.
Loosen the transaxle mounting bracket to frame
fasteners. Do not remove fasteners at this time.
10.
Remove the drive wheels.
11.
Disconnect
the
parking
brake
linkage.
Disassemble and remove parking brake lever
and cable assembly from steering column
mounting. Requires loosening and removal of
steering column lower mounting bracket.
Refer to Section 8. 1, Service Brake and Inching
Systems.
12.
Disconnect wiring leads from control valve.
Refer to Section 7.12, Directional (Shaft) Control
Linkage.
13.
Remove the accelerator linkage, as required, to
permit transaxle removal. Check by inspection
to determine necessity to remove.
14.
Disconnect the power steering lines from the
steering gear (valve) and move out of the way.
Plug fittings and cap open ends of lines to
prevent drainage and entrance of dirt. Mark, tag
or otherwise identify the proper position of the
lines to be sure of correct reassembly.
Refer to Section 9.0, Steering System.
F-333
|
