TM 10-3930-671-24 REAR HOUSING REMOVAL - 1.  Remove four 1032 X 31/8" through bolts which retain rear housing to front, Figure No.  23. FIGURE NO.  23. 2. Using    two    screwdrivers,    gently    apply    equal pressure  to  release  the  rear  housing  from  front (Figure  No.    24).    Care  should  be  taken  when prying the housing apart to avoid damage to the metal facing of the rear or front housings.  When the  pressure  seal  has  been  released,  the  rear housing  may  be  grasped  and  lifted  gently  from the  front  housing.    The  rear  housing  will   only "pull  away"  from  the  front,  the  distance  of  the length of the diode leads from the stator (Figure No.  25). NOTE At    this    time,    inspect    the    housing gasket.        Should    the    gasket    show signs of damage, it should be replaced. FIGURE NO.  24. FIGURE NO.  25. DIODE HEAT SINK REMOVAL- 1. Remove  three  10-24  x  3/8"  hex  nuts,  retaining stator leads to heat sink terminal screws (Figure No. 26)  Lift stator leads off, separate stator from the rear housing. FIGURE NO.  26. 2. Holding the rear housing on its’ side, remove the two  10-24  hex  nuts  and  one  1/4-28  nut.    Then, remove   the    split    lockwashers    and    remaining nuts, washers, etc.  (Figure No.  27). FIGURE NO.  27. F-287