| |
TM 10-3930-671-24
Before starting engine, switch system knob of ammeter to DIRECT, or if a separate resistor is used, by-pass resistor with
short, heavy (No. 10 wire) jumper cable. (Carbon Pile is not used). Start engine and run for 5 minutes at fast idle to
normalize temperature of components. Insert series resistance in circuit, with knob or removing jumper on separate
resistor. Charging current should drop to 8-10 amperes, voltmeter will indicate voltage regulator setting, refer to Table No.
1, for temperature corrected settings.
TABLE 1.
REGULATOR AMBIENT TEMPERTUER
If higher voltage is indicated, check regulator leads 3 and 4 for secure connections. A jumper cable with insulation piercing
alligator clips (Figure No. 15) may be used to by-pass any plug-in connector that may present an intermittent circuit
(Figure No. 16). Repair or replace doubtful leads or connectors.
FIGURE NO.15.
FIGURE NO. 16.
F-282
|