TM 10-3930-671-24 (5) Extend   all   hydraulic   cylinders,   coat   rods with  bearing  grease,  and  then  fully  retract cylinders. (6) Clean truck thoroughly. (7) Check truck thoroughly for worn or damaged components and repair or replace as required. (8) Change engine oil and replace oil filter. (9) Replace air cleaner element. (10) Fill fuel tank with fuel and add inhibitor. (11) Clean   exterior   of   engine   and   coat   with rust-preventative lubricant. (12) Lubricate     entire     truck     per     Lubrication Order given in Appendix E. (13) Park   truck   with   forks   fully   lowered   and spread,  upright  tilted  fully  backward,  and carriage centered on upright. (14) Seal all engine openings with weatherproof tape. (15) Engage parking brake. b. Long-Term Storage (Longer than 30 days) (1) Perform all preventive maintenance according  to  instructions  given  in  Chapter 3. (2) Start engine and allow to warm up. (3) Raise and lower forks fully several times. (4) Fully   tilt   upright   forward   and   backward several times. (5) Extend   all   hydraulic   cylinders,   coat   rods with  bearing  grease,  and  then  fully  retract cylinders. (6) Check truck thoroughly for worn or damaged components and repair or replace as required. (7) Change engine oil and replace oil filter. (8) Clean   exterior   of   engine   and   coat   with rust-preventative lubricant. (9) Replace air cleaner element. (10) Fill fuel tank and add 3 ounces (90 ml) of inhibitor to the fuel tank. (11) Drain    hydraulic    reservoir,    change    main hydraulic    filters,    and    fill    reservoir    with recommended fluid. (12) Lubricate     entire     truck     per     Lubrication Order given in Appendix E. (13) Park   truck   with   forks   fully   lowered   and spread,  upright  tilted  fully  backward,  and carriage centered on upright. (14) Ensure   that   direction   control   levers   are centered (NEUTRAL). (15) Engage parking brake. (16) Remove and clean batteries. Store batteries   in   a   cool,   dry   place   and   keep them fully charged. (17) Disconnect    air    intake    piping    from    the manifold.    Pour    3    ounces    (90    ml)    of inhibitor   into   intake   system   and   connect the piping. (18) Seal all engine openings with weatherproof tape. (19) Clean  exterior  of  the  truck  and  touch  up any scratched, chipped, or painted surfaces. (20) Coat   all   unpainted   metal   surfaces   with grease or corrosion inhibitor. 1-7 (1-8 blank)