TM 10-3930-671-24 WARNING Use   care   when   installing   springs.      Latch   springs   are   under   spring   tension   and   can   act   as projectiles when released and could cause severe eye injury. (g) Install spring (34), handle (33), spring (32), spacer (31), lever (29), and spring (30) on top hood (16) with pin (28). (h) Install hood latch assembly (23) on top hood (16) with pin (24), two screws (27), four washers (26), and two nuts (25).  Tighten nuts 180-220 lb-in (20-25 N•m). WARNING Use   care   when   installing   springs.      Latch   springs   are   under   spring   tension   and   can   act   as projectiles when released and could cause severe eye injury. (i) Install spring (42) in bracket (44) with screw (43) and nut (41).  Tighten nuts 180-220 lb-in (20-25 N•m). (j) Install pin (47), in bracket (44) with washer (46), and pin (45). (11) To install top hood (16), proceed as follows: NOTE Support the weight of the top hood during installation with the aid of an assistant. (a) With the aid of an assistant, install top hood (16) on seat hinge bracket (21) and bracket (22) with spring gas cylinder assembly (18), two pins (20), and retaining rings (19). (b) With the aid of an assistant, install two nuts (17) on spring gas cylinder assembly (18). Tighten nuts 180-220 lb-in (20-25 N•m). (c) Install insulation on top hood (Para 3-37). (d) Install seat on top hood (Para 3-36). (12) Install left-side and right-side hoods (TM 10-3930-671-10). 3-106