TM 10-3930-671-24 CAUTION Use  care  when  removing  hose  from  brake  fluid  reservoir  and  fitting  to  breaking  connections. Connections can be easily broken, causing damage to equipment. NOTE • Position suitable container with one quart (1 liter) capacity under brake master cylinder. • Tag and mark all wires, lines, and hoses prior to removal. • Use wiping clothes to wipe up any spilled brake fluid. (5) Remove clamp (1), cut hose (2) from brake fluid reservoir (3), and drain brake fluid into suitable container. (6) Loosen clamp (4) and remove brake fluid reservoir (3). (7) Remove clamp (5) and cut hose (2) from fitting (6).  Discard hose. (8) Remove two remaining hose sections (2) from brake fluid reservoir (3) and fitting (6).  Discard hose. (9) Remove brake lines (7 and 8) from two fittings (9). (10) With the aid of an assistant, remove nut (10) and screw (11) from bracket (12) and forklift (13). Note Note position of wire and strap prior to removal. (11) Remove six nuts (14), screws (15), two straps (16 and 17), wire (18), two harness sections (19), and bracket (12) from forklift (13) and position on clean work surface. (12) Remove nut (20), screw (21), and retainer (22) from bracket (12) and pivot (23). (13) Remove two retainers (24) and pins (25) from pedals (26 and 27), and two brake master cylinders (28). (14) Remove pivot (23), pedals (26 and 27), and four bushings (29) from bracket (12). (15) Remove two fasteners (30) and pads (31) from pedals (26) and (27). (16) Remove locking nut (32) and screw (33) from bracket (12). (17) Remove four clamps (34), fitting (6), and hoses (35 and 36) from two brake master cylinders (28). (18) Remove two nuts (37), screws (38), and two brake master cylinders (28) from bracket (12). (19) Remove two fittings (9) and seals (39) from two brake master cylinders (28).  Discard seals. 3-80