TM 10-3930-671-24 3-28. PARKING BRAKE LEVER REPLACEMENT. a. Removal (1) Chock wheels to prevent roll. (2) Disconnect batteries (Para 3-25). (3) Release parking brake (TM 10-3930-671-10). (4) Remove two nuts (1), screws (2), and brake handle assembly (3) from mounting bracket (4). (5) Remove cotter pin (5), washer (6), pin (7), and brake cables (8) from brake handle assembly (3).  Discard cotter pin. (6) Remove two cotter pins (9), pins (10), and clamps (11) from brake cables (8).  Discard cotter pins. (7) If necessary, remove nut (12), screw (13), and two fastener halves (14) from brake cables (8). b. Installation (1) If removed, install two fastener halves (14) on two brake cables (8) with screw (13) and nut (12). (2) Install two clamps (11) on two brake cables (8) with pins (10) and cotter pins (9). (3) Install two brake cables (8) in brake handle assembly (3) with pin (7), washer (6), and cotter pin (5). (4) Install brake handle assembly (3) on mounting bracket (4) with two screws (2) and nuts (1).  Tighten screws 180- 220 lb-in (20-25 N•m). (5) Adjust parking brake assembly (TM 10-3930-671-10). (6) Apply parking brake (TM 10-3930-671-10). (7) Remove wheel chocks. (8) Connect batteries (Para 3-25). END OF TASK 3-78