| |
TM 10-3930-671-24
b.
Installation.
(1)
To install battery cables, proceed as follows:
(a)
Raising cover (12), install positive battery
cable (15) on master power switch terminal
(16) with lockwasher (14) and nut (13).
WARNING
Corrosion inhibitor contains alkali.
Do
not
get
in
eyes;
wear
goggles/safety glasses when using.
Avoid contact with skin. in case of
contact, immediately wash area with
soap
and
water.
If
eyes
are
contacted,
flush
eyes
with
large
amounts of water for at least 15
minutes and get immediate medical
attention.
(b)
Coat two positive battery terminals (11)
with corrosion preventive compound.
(c)
Install
two
positive
battery
terminal
clamps (10) on two positive battery terminals ( 11) with
two nuts (9).
(d)
Position two battery terminal covers (8)
on two positive battery terminal clamps (10).
(e)
Install washer (6), negative battery cable
(5), and screw (4) on engine (7).
(f)
Coat two negative battery terminals (3) with
corrosion preventive compound.
(g)
Install two negative battery terminal clamps
(2) on two negative battery terminals (3)
with two nuts (1).
(2)
Install left-side hood (TM 10-3930-671-10).
(3)
Close top hood (TM 10-3930-671-10).
(4)
Install right-side hood (TM 10-3930-671-10).
(5)
Remove wheel chocks (TM 10-3930-671-10).
END OF TASK
3-75
|
