TM 10-3930-671-24 (b) Loosen two nuts (3) on two negative battery terminal clamps (4). (c) Remove     two     negative     battery     terminal clamps     (4)     from     two     negative     battery terminals (5). (d) Raising   two    battery    terminal    covers    (6), loosen  two  nuts  (7)  on  two  positive  battery terminal clamps (8). (e) Raising   two    battery    terminal    covers    (6), remove two positive battery terminal clamps     (8)     from     two     positive     battery terminals (9). (f) Remove  two  nuts  (10),  four  washers  (11), and battery hold down (12) from two J-bolts (13). (g) Remove  two  batteries  (14)  and  position on clean work surface. b. Installation. NOTE If connecting battery after maintenance procedure, perform Steps (1)[f] through (3) only. (1) To install batteries, proceed as follows: WARNING Battery  hold  down  must  be  installed  with  the  long  side  toward  the  front  of  vehicle.    Failure  to install   in   this   manner   could   cause   shorting   of   battery,   damage   to   equipment,   and   injury   to personnel. (a) Install two batteries (14) in with two J-blots (13), battery hold down (12), four washers (11), and two nuts (10). 3-72