TM 10-3930-671-10 1-4. PERFORMANCE CHARACTERISTICS. a. Engine.    The  truck  is  powered  by  a  Continental water-cooled,   4-cylinder,   in-line   diesel   engine.      Model TMD-27 has 164 cubic inch (2.68 l) displacement which develops 60 hp at 3100 rpm. b. Transaxle. One-speed transaxle delivers maximum   torque,   100   Ib-ft   at   converter   stall   in   both forward and reverse. c. Upright.  3-stage upright allows loads up to 4000 lbs.  (1814.4 kg) to be lifted to a maximum height of 184 inches   (4674   mm).      Hydraulic   tilt   capability   allows   a maximum   arc   of   2.5   ±   .5   degrees   forward   tilt   and   6 degrees reverse tilt. d. Lifting Forks.  Width between forks is adjustable from  0  to  40  inches  (0-1016  mm).    Forks  shift  left  or right, in tandem, 3.9 inches (99 mm) each way for a total distance of 7.8 inches (198.1 mm). 1-5. ENVIRONMENTAL INFORMATION. The    truck    has    sound    suppression,    air    cleaner    with replaceable element, and replaceable engine, transmission, and hydraulic oil filters. 1-6. TOOLS AND TEST EQUIPMENT. There are no special tools or test equipment required to maintain the truck in operation. 1-7. SHIPPING AND HANDLING INSTRUCTIONS. Refer to Chapter 2 for shipping and handling instructions. 1-8. STORAGE DATA. Short-Term Storage (30 days or less): (1) Start engine and allow to warm up. (2) Raise and lower forks fully several times. (3) Fully  tilt  upright  forward  and  backward  several times. (4) Coat    all    exposed,    polished    parts    with    rust- preventive lubricant. (5) Extend all hydraulic cylinders and coat rods with bearing grease; then, fully retract cylinders. (6) Clean truck thoroughly. (7) Check   truck   thoroughly   for   worn   or   damaged components and repair or replace as required. (8) Change engine oil and replace oil filter. (9) Replace air cleaner element. (10) Fill  fuel  tank  with  fuel  and  add  3  oz    (90  ml)  of inhibitor. (11) Clean   exterior   of   engine   and   coat   with   rust- preventive lubricant. (12) Lubricate  entire  truck  per  instructions  given  in TM 10-3930-671-24. (13) Park  truck  with  forks  fully  lowered  and  spread, upright tilted fully backward, and carriage centered on upright. 1-6