| |
TM 10-3930-669-34
b. Cleaning/Inspection.
WARNING
•
Dry-cleaning solvent (P-D-680) is TOXIC and flammable. Wear protective goggles and
gloves; use only in a well-ventilated area; avoid contact with skin, eyes, and clothes; and do not
breathe vapors. Keep away from heat or flame. Never smoke when using solvent; the flashpoint
for type I dry-cleaning solvent is 100°F (38°C) and for type II is 138°F (50°C). Failure to do so may
result in injury or death to personnel.
•
If personnel become dizzy while using cleaning solvent, immediately get fresh air and
medical help. If solvent contacts skin or clothes, flush with cold water. If solvent contacts eyes,
immediately flush eyes with water and get immediate medical attention.
(1)
Clean all metal parts with dry-cleaning solvent and wipe dry with wiping rag.
(2)
Flush reservoir with dry-cleaning solvent and allow to air dry.
(3)
Inspect all parts for breaks, cracks, burrs, and sharp edges. Inspect all hoses, lines, and fittings for cracks, bends,
nicks, dents, stripped threads, and cuts. Replace all damaged parts.
C
Installation.
NOTE
Coat
preformed
packings
with
hydraulic fluid prior to installation.
(1)
Install preformed packing (16) and elbow (10) in
hydraulic reservoir (13).
(2)
Install preformed packing (15) and elbow (8) in
hydraulic reservoir (13).
(3)
Install preformed packing (14) and elbow (6) in
hydraulic reservoir (13).
15-71
|
