TM 10-3930-669-34 15-9.  PIVOT AND SHIFT ASSEMBLY REPLACEMENT/REPAIR (CONT). (17) Using 30 ton ram, press side shift shaft (7) main end cap (6) and bearing cap (5) into side shift housing (1). (18) Install main end cap (6) on shaft (7) with four screws (8).  Tighten screws to 105 lb-ft (142.36 N.m). NOTE • Left side bearing halves shown but   both   sides   installed   the   same way. • Using   50   ton   jack,   slide   the pivot   and   shift   assembly   over   the bearing halves. (19) Using bearing tool and four clamps,  install  eight bearing halves (9) into side shift housing (1). 15-66