| |
TM 10-3930-669-34
14-2.
CAB GLASS REPLACEMENT (CONT).
b.
Cleaning/lnspection.
WARNING
•
Dry-cleaning solvent (P-D-680) is TOXIC and flammable. Wear protective goggles and
gloves; use only in a well-ventilated area; avoid contact with skin, eyes, and clothes;
and do not breathe vapors. Keep away from heat or flame. Never smoke when using
solvent; the flashpoint for type I dry-cleaning solvent is 100°F (38°C) and for type II is
138°F (50°C). Failure to do so may result in injury or death to personnel.
•
If personnel become dizzy while using cleaning solvent, immediately get fresh air and
medical help. If solvent contacts skin or clothes, flush with cold water. If solvent
contacts eyes, immediately flush eyes with water and get immediate medical attention.
(1)
Clean all metal parts with dry-cleaning solvent and wipe dry with wiping rag.
(2)
Remove all sealing compound residue from glass, seals, and frames.
(3)
Inspect all parts for breaks, cracks, burrs, and sharp edges.
(4)
Replace all damaged parts.
c.
Installation.
NOTE
•
If seal was removed during
removal, perform step (1).
•
If seal was not removed during
removal, proceed to step (2).
(1)
Install seal (1) on cab (2).
(2)
Apply sealing compound to outer surface of
channel (15).
(3)
Install channel (15) in frame assembly (3).
14-6
|
