TM 10-3930-669-34 12-5.  STEERING CONTROL PUMP REPAIR (CONT). NOTE Clean   upper   surface   of   housing   by wiping    with    palm    of    clean    hand. Clean    each    flat    surface    of    meter section   parts   the   same   way   before reassembling. (13) Install  preformed  packing  (11)  and  spacer  plate (10)  on  control  pump  housing  (1).    Align  screw holes in spacer plate with tapped holes in control pump housing. NOTE When   installing   drive   in   spool   and sleeve, make sure drive engages pin. (14) Install drive (9) in control pump housing (1). CAUTION When installing meter, be careful not to drop star, or damage may result. NOTE Side   of   star   with   chamfer   on   inner splines faces inside of control pump. (15) Install   preformed   packing   (8)   and   star   (6)   in meter   (7);   install   assembled   meter   on   control pump housing (1). NOTE It  may  be  necessary  to  remove  and install  meter  a  few  times  until  holes line up and star fits over drive. (16) Align screw holes in meter (7) with tapped holes in  control  pump  housing  (1)  while  fitting  star  (6) easily over drive (9). (17) Install spacer (5) in star (6). 12-22