| |
TM 10-3930-669-34
10-4.
DIFFERENTIAL REPAIR (CONT).
e.
Installation.
NOTE
•
Shims will be placed on the pinion shaft assembly during installation to place end of pinion shaft
assembly at the correct distance from centerline of the differential. This distance must be 4.4 in.
(112 mm).
•
Perform all measurements required to determine the shims to be installed with the pinion shaft
cover prior to installing components in the differential housing.
(1)
Measure
inside
shaft
diameter
of
differential (18). Designate this distance
as Distance A.
(2)
Mark a point on the outside diameter of
differential (18).
(3)
Measure the radius distance from the
inside shaft diameter to the mark point on
the outside diameter of differential (18).
Designate this distance as Distance B.
(4)
Apply lubricating oil to two seals (17) and
two seals (16).
(5)
Install seal (17) and seal (16) on right
intermediate
cover
(3)
and
left
intermediate cover (2).
(6)
Position bearing race (14) and ring nut
(13) in right intermediate cover (3) as
noted during removal.
CAUTION
Use care when placing differential
inside differential housing or damage
to equipment could result.
(7)
Install
right
intermediate
cover
(3),
differential (18), and left intermediate
cover (2) on differential housing (10) with
four screws (15).
(8)
Position bearing race (14) and ring nut
(13) in left intermediate cover (2) as noted
during removal.
10-26
|
