TM 10-3930-669-34 c. Installation. WARNING Adhesive  causes  immediate  bonding  on  contact  with  eyes,  skin,  or  clothing  and  also  gives  off harmful vapors.  Wear protective goggles and use in well-ventilated area.  If adhesive gets in eyes, try to keep eyes open; flush eyes with water for 15 minutes and get immediate medical attention. NOTE Left    and    right    axle    housings    are installed   the   same   way.      Left   axle housing shown. (1) Apply sealing compound to twelve studs (5). (2) Install   twelve   studs   (5)   in   differential   housing assembly (8).  Tighten to 63 lb-ft (86 N•m). (3) Coat seal (7) with lubricating oil. (4)    Install  seal  (7)  on  differential  housing  assembly (8). WARNING Axle  housing  with  brakes  weighs  85 lbs   (39   kg).      Attach   suitable   lifting device prior to removal or installation to prevent possible injury to personnel. NOTE Position    axle    in    housing    to    align brake disks during assembly. (5)    Position axle housing assembly (2) on differential housing assembly (8). (6) Apply sealing compound to twelve studs (5) and two studs (6). (7) Install fourteen nuts (4) on twelve studs (5) and two studs (6).  Tighten to 63 lb-ft (86 N•m). (8) Install plug (3) in axle housing assembly (2). (9) Install seal (1) in axle housing assembly (2). NOTE Follow-on Maintenance: • Install planetary hubs (Para 9-2). • Install drive axle (Para 10-2). END OF TASK 10-11