| |
TM 10-3930-669-34
10-2.
DRIVE AXLE REPLACEMENT (CONT).
b.
Cleaning/lnspection.
WARNING
Dry-cleaning solvent (P-D-680) is TOXIC and flammable. Wear protective goggles and gloves;
use only in a well-ventilated area; avoid contact with skin, eyes, and clothes; and do not
breathe vapors. Keep away from heat or flame. Never smoke when using solvent; the
flashpoint for type I dry-cleaning solvent is 100°F (38°C) and for type II is 138'F (50'C). Failure
to do so may result in injury or death to personnel.
If personnel become dizzy while using cleaning solvent, immediately get fresh air and medical
help. If solvent contacts skin or clothes, flush with cold water. If solvent contacts eyes,
immediately flush eyes with water and get immediate medical attention.
(1)
Clean all metal parts with dry-cleaning solvent.
(2)
Inspect all parts for wear, cracks, nicks, burrs, or scratches.
(3)
Replace all damaged parts.
c.
Installation.
(1)
Attach lifting device to axle (4).
(2)
With the aid of an assistant to stabilize axle on floor jack, position axle (4) on floor jack, remove lifting device, and
attach to axle with chains.
(3)
With the aid of an assistant to stabilize axle on floor jack, position axle (4) under forklift.
(4)
Apply sealing compound to threads of eight screws (25).
(5)
Install eight screws (25), eight washers (24), eight nuts (23), and eight washers (22) in forklift and axle (4).
Tighten nuts to 230 to 300 lb-ft (311-407 Nm).
(6)
Remove floor jack and chains from axle (4).
10-6
|