TM 10-3930-669-34 9-2. PLANETARY HUB REPLACEMENT/REPAIR (CONT). NOTE • If  the  force  required  to  turn  the wheel   hub   is   not   as   specified, perform      v   Removal   Steps   (5) through   (10).      Add   or   subtract shims,  as  required,  and  perform Installation    Steps    (11)    through (15). • If  the  force  required  to  turn  the wheel  hub  is  correct,  proceed  to Step (16). (16) Install axle (8) in axle housing (7). (17) Install  seal  washer  (6)  and  plug  (5)  in  planetary gear carrier (2). (18) Coat seal (3) with lubricating oil. (19) Install seal (3) on wheel hub (4). WARNING Adhesive  causes  immediate  bonding on    contact    with    eyes,    skin,    or clothing  and  also  gives  off  harmful vapors.  Wear protective goggles and use    in     well-ventilated     area.          If adhesive   gets   in   eyes,   try   to   keep eyes  open;  flush  eyes  with  water  for 15     minutes     and     get     immediate medical attention. (20) Apply sealing compound to threads of four screws (1). (21) Install  planetary  gear  carrier  (2)  on  wheel hub (4) with four screws (1).  Tighten to 63 lb-ft (86 N•m). NOTE Follow-on Maintenance: • Install drive axle (Para 10-2). END OF TASK 9-12