TM 10-3930-669-34 8-8. TORQUE CONVERTER REPLACEMENT/REPAIR (CONT). c. Cleaning/lnspection. WARNING • Dry-cleaning solvent (P-D-680) is TOXIC and flammable.  Wear protective goggles and gloves; use only in a well-ventilated area; avoid contact with skin, eyes, and clothes; and do not breathe vapors.  Keep away from heat or flame.  Never smoke when using solvent; the flashpoint  for  type  I  dry-cleaning  solvent  is  100°F  (38°C)  and  for type II is 138°F (50°C).  Failure to do so may result in injury or death to personnel. • If personnel become dizzy while using cleaning solvent, immediately get fresh air and medical  help.    If  solvent  contacts  skin  or  clothes,  flush  with  cold  water.    If  solvent contacts eyes, immediately flush eyes with water and get immediate medical attention. CAUTION Do   not   allow   solvent   or   contaminants   to   enter   torque   converter;   damage   to   torque converter and transmission can result. (1) Clean all metal parts with dry-cleaning solvent and wiping rags. (2) Inspect all parts for breaks, cracks, burrs, sharp edges, and signs of overheating. d. Assembly.     Install   drive   plate   (4)   and   spacer ring (8) on torque converter (3) with six washers (7) and screws (6).  Tighten screws (6) to 30 lb-ft (41 N•m). 8-66