TM 10-3930-669-34 8-7. FORWARD SHAFT REPLACEMENT/REPAIR (CONT). CAUTION Parts     held on forward shaft by bearing   are   not   a   press   fit.      These parts will come off shaft when bearing is removed. (2) Using a puller, remove bearing (4) from forward shaft (1). (3) Remove   thrust   washer   (5)   and   gear   (6)   from forward shaft (1). (4) Remove bearing (7), spacer (8), bearing (9), and two   thrust   washers   (10   and   11)   from   forward shaft (1). WARNING Use care when removing or installing snap  and  retaining  rings.    Snap  and retaining rings are under spring tension   and   can   act   as   projectiles when released and could cause severe eye injury. (5) Remove  retaining  ring  (12)  and  pressure  plate (13) from forward shaft (1). (6) Remove   friction   clutch   plates   (14)   and   steel clutch plates (15) from forward shaft (1). 8-54