| |
TM 10-3930-669-34
8-6.
INPUT SHAFT REPLACEMENT/REPAIR (CONT).
(13)
Coat gear (23) and thrust washers (22 and 21)
with clean transmission oil.
NOTE
Rotate gear during installation to
ensure it has meshed with all friction
clutch plates.
(14)
Install gear (23) on bearing (24) and into friction
clutch plates (30).
(15)
Install thrust washers (22 and 21) on input shaft
(1).
(16)
Coat bearing (20) with clean transmission oil.
NOTE
Components on input shaft, under
bearing, should not be loose after
bearing is installed.
(17)
Using a press, install bearing (20) on input shaft
(1) until it seats firmly against thrust washer (21).
8-48
|